How do I program my 900 WaterBoss?

Program your hardness setting into the controller pad. Push the SET button and hold for three seconds to display a default hardness number. Push the CHANGE button until the number displayed matches your hardness setting number, and then press SET to save the number.

How do I reset my WaterBoss 900?

Resetting the Unit To reset the unit, remove the transformer from the power outlet, then let the WaterBoss rest for 30 seconds before plugging the transformer back into the wall. This cycles the water softener’s power, sometimes enabling the controller to find the home position once again.

How long does a WaterBoss softener last?

between 10 and 15 years
Just like any other appliance, a water softener will only last for so long. Eventually, components break, electrical problems occur, and it just stops working. While they can last much longer if well maintained, water softeners have a typical lifespan of between 10 and 15 years.

What kind of salt do you use for Waterboss?

For a salt substitute, potassium chloride may be used. However, potassium chloride is not recommended when iron is present in the water supply. When there is iron in the water, pellet salt with a rust remover is recommended. The use of rock salt is not recommended because it contains impurities.

How much water should be in a brine tank?

Wet Brine Tanks: That works out to about 15-25 cm (6-10 inches) of water. The water will be in your tank even in between regeneration times or cycles. You may not see the water if your salt level is higher than your water level.

How do I reset my digital water softener?

To adjust the time, press the down arrow (or up arrow, depending on what time you are changing to). Hold the arrow until you reach the correct time of day. Then, press the cycle button (which looks like a circular pattern of arrows) and you’re all done!

How often should my iron filter regeneration?

every three days
This iron filter replenishes itself every three days in a process that washes the stored iron out of the filter bed and down the drain while refilling the compressed air bubble. This all happens automatically during the night.

How do I know if my water softener is bad?

Immediate signs of hard water that reveal trouble with your water softener include:

  1. Soap not lathering.
  2. Clothes feeling rough or appear dingy after laundry.
  3. Spots or streaks on dishes or glassware.
  4. Dull, lifeless hair or dry, itchy skin.
  5. Soap scum on the shower, tub, and other surfaces.


By Tips