What kind of oil does 2004 Chevy Malibu take?
SAE 5W-30
Engine Oil
| Viscosity: | 10W-30 (Above -18) 5W-30 (All TEMPS) SAE 5W-30 is preferred. |
|---|---|
| Capacity: | 4 quarts (with filter)After refill check oil level. |
| Torque: | 18 ft/lbs (Oil Drain Plug) |
What kind of oil does a Chevy Malibu need?
The 2019 Chevrolet Malibu requires full synthetic oil, SAE 0W-20 for the 1.5L 4 -cylinder engine – which holds 4.2 quarts.
Can a Chevy Malibu take 10W-30?
What type of oil change does my Chevrolet Malibu need? It is recommended to use for Chevrolet Malibu cars the appropriate API SN, API SP classification and approvals General Motors, with viscosity 0W-20, 5W-20, 5W-30 or 10W-30.
How much oil does a 3.5 Chevy Malibu take?
Model: Chevrolet Malibu (USA)
| Engine | Capacity/Filter | |
|---|---|---|
| Malibu 3.5 V6 (2004 – 2006) | LX9 | 3.8 l 4.02 US Quarts / Filter: n/a |
| Malibu Limited 2.5 VVT (2016 – ) | LCV | 4.7 l 4.97 US Quarts / Filter: n/a |
| Malibu 2.5 VVT (2013 – 2016) | LKW | 4.7 l 4.97 US Quarts / Filter: n/a |
| Malibu 3.5 V6 (2007 – 2008) | LZ4 | 3.8 l 4.02 US Quarts / Filter: n/a |
How much oil does a 2004 Chevy Malibu take?
Engine Oil SAE 5W-30 is preferred. Capacity: 4 quarts. (with filter)After refill check oil level.
How much oil does a 2005 Chevy Malibu V6 take?
Capacity: 4 quarts (with filter)After refill check oil level.
Does Chevy Malibu require synthetic oil?
How often does a Chevy Malibu need an Oil Change? Synthetic oil usually should be changed every 7,500 – 10,000 miles. Chevy recommends getting your Chevy Malibu oil & filter changed every 3,000-5,000 miles for conventional oil.
How much oil goes in a Chevy Malibu?
Engine Oil
| Viscosity: | 0W-20 (All TEMPS) Synthetic fluid required |
|---|---|
| Capacity: | 4.2 quarts (with filter)After refill check oil level. |
| Torque: | 18 ft/lbs (Oil Drain Plug) |
What kind of oil goes into a 2008 Chevy Malibu?
5W-30
Engine Oil
| Viscosity: | 5W-30 (All TEMPS) |
|---|---|
| Capacity: | 5.5 quarts. . . (with filter)After refill check oil level. |
| Torque: | 18 ft/lbs (Oil Drain Plug) |
What kind of oil goes in a 2020 Chevy Malibu?
Synthetic Motor Oil
Chevy Malibu 2020, SAE 0W-20 Full Synthetic Motor Oil, 1 Quart by Idemitsu®. Formulated to operate with lower friction to provide better torque, horsepower and fuel economy without sacrificing long-term protection.
How much oil does a 2004 Chevy Malibu V6 take?
The 2004 Chevy Malibu has two different engine sizes and each one will require different oil capacity. The oil capacity for the 2.2L i-4 iS4. 5 us quarts (4.3 liters) and the 3.5L v6 has A5 quarts (4.8 Liters). The manufacturer advises consumers to use licensed engine oils with the dexos1® approved certification mark.
What kind of oil do I need for a Chevy Malibu?
The owner’s manual of this 2006 Chevrolet Malibu specified that 4 quarts of SAE 5W-30 oil is needed for an oil change with a new oil filter. Some compatible oil filters for the GM 3500 3.5L V6 engine include the Purolator PL10111, ACDelco PF47, Mann-Filter ML 1000, Fram PH3387A and Pennzoil HPZ-9A.
Where is the oil filter on a Chevy Malibu?
The 13mm oil drain bolt is located at the rear of the engine’s oil pan facing towards the back end of the car. The engine’s oil filter is located just in front of the oil pan and behind an exhaust pipe. Since used engine oil can contain carcinogens (cancer causing agents), it’s recommended that you wear latex gloves.
What kind of engine does a Chevy Malibu have?
Owners of other General Motors vehicles equipped with the 3500 V6 engine such as the Pontiac G6, Montana, Buick Terraza, Rendezvous, Chevrolet Uplander, Impala, Monte Carlo, Saturn Relay, and Aura may also find this guide to be helpful.
What kind of oil do you put in a GM 3500?
The GM 3500 3.5L V6 engine requires 4 US Quarts of new SAE 5W-30 oil for an oil change with a new oil filter. Pour in about 3.5 quarts of oil, run the engine for a minute, allow it to rest for a few minutes, and then check the oil level on the dipstick.