How much is a control board for a Goodman furnace?
Compare with similar items
| This item Goodman Parts PCBBF132S Control Board | Upgraded Replacement for Goodman Furnace Control Circuit Board B18099-13 | |
|---|---|---|
| Add to Cart | Add to Cart | |
| Customer Rating | 4.7 out of 5 stars (228) | 4.5 out of 5 stars (186) |
| Price | $4800 | $96.99$96.99 |
| Sold By | Online Plumbing & Heating | UR SUPPLY DIRECT |
What causes HVAC control board failure?
Failed transistors: The transistors in the control board are susceptible to damage due to power surges, static electricity, and age. Transistors are often the first part of a control board to fail. Loose wiring: The vibrations of the furnace over the years can cause wiring in the control board to shake loose.
How do I reset my Goodman control board?
Press and hold the red “Reset” button in the center of the rollout limit switch component. Hold the button for one to two seconds before releasing it.
How much does it cost to replace a furnace circuit board?
Replacing a furnace control board typically costs $200 to $600 or more depending on brand and age. It’s the main circuitry responsible for operating the components. High efficiency models will cost close to $600 while simple, single-stage models may only run you $75 to $200, the price of a service call.
How much is a furnace control board?
Where is the circuit board on a Goodman furnace?
The circuit board on a Goodman home furnace lies at the system’s center.
How long does furnace circuit board last?
It cause strain against the motor and draw too much power, which causes the system to short. Secondly, how long does a furnace control board last? It seems about 7-10 years has become the norm for expected life cycles in consumer electronic devices, appliances etc.
What does a blinking red light mean on a Goodman furnace?
Interpret one LED flash that blinks on and off to mean your furnace has locked out because it could not ignite after three tries, and must be reset. Interrupt power to your furnace for 20 seconds or lower the thermostat so your furnace does not try to heat, then reset the thermostat to the previous setting.
Can you fix a burnt circuit board?
Apply the circuit board epoxy over the damaged area with a cotton swab, building up the surface so it is even with the top of the circuit board. Use the tip of a small spatula to level the epoxy material, creating an even surface. Allow the epoxy to dry and cure according to directions.
What are the symptoms of a bad furnace control board?
Here are signs you may have a malfunctioning furnace control board: Uncomfortable temperatures: If your furnace starts to make you either too hot or too cold, and the thermostat settings seem fine, then the problem might be a control board that is turning components off too soon or letting them run too long.
What is a furnace circuit or control board?
What exactly is a furnace circuit board? A furnace circuit board is similar to a computer’s circuit board. It’s the “brain” of the appliance. Therefore, it controls everything from the sequence functions are supposed to be performed with, to the most fundamental elements like what temperature the furnace is working at.
What is the Control Board in a furnace?
A furnace control board is similar to a computer circuit board. It’s the furnace’s brain. It operates all functions, in the order they are to occur. It controls everything the furnace does each heating cycle. Because they are a sophisticated electronic, they can fail & must be replaced.