How do you make a Seagate Barracuda slave drive?

Drive is slave: To configure the drive as a slave or second drive on the cable, remove all the jumpers from pins 5-8. Master with non-ATA compatible slave: Use this setting if the slave drive is not recognized. Configure the master drive with a jumper set on pins 5 and 6 and pins 7 and 8 to enable this option.

What is the purpose of the jumpers on an IDE hard drive?

You may have pins on the back of your hard drive that nothing is connected to. These pins are called jumpers, and are used to enable specific types of settings. You enable particular settings by placing a jumper shunt onto specific pins—creating an electrical circuit between them.

How to slave a desktop drive?

Using the arrow keys, find and select the hard drive that you attached to the computer. Change the hard drive to “Slave” status. You’ll use the “Configure” or “Change” key to do this as well. Once you see “Slave” to the right (or near) the drive’s name, you can proceed.

What is IDE hard drive?

Integrated Drive Electronics (IDE) is a standard interface for connecting a motherboard to storage devices such as hard drives and CD-ROM/DVD drives. The original IDE had a 16-bit interface that connected two devices to a single-ribbon cable. Prior to IDE, controllers were separate external devices.

What is a master and slave drive?

The use of “master” and “slave” goes back decades. For hard drives, the terms designate which of a pair controls a shared interface in a computer’s internal communications system. You might have seen it in data storage, where a master database is a primary repository and a slave database is a synchronized copy.

How do I slave drive my laptop?

How to Slave a Laptop Hard Drive

  1. Shut down your laptop and remove the power cord.
  2. Grasp the hard drive by the front bezel and pull it out of the laptop.
  3. Connect the USB cord from the laptop drive enclosure to a free USB port on a working desktop or laptop.

How to Change master and slave drive?

Steps

  1. Restart your computer.
  2. If prompted for a password, enter it and press the “Enter” key.
  3. Navigate to the “CMOS Setup” and press “Enter”.
  4. In the CMOS menu, find “Hard Disk” and then the “Primary Master” selection.
  5. Move the cursor to the “Primary Slave” selection and press “Enter” again.
  6. Edit step.

What should the jumper settings be for Seagate?

Master or single drive. If you are installing your Seagate hard drive as the only drive in the system or if it will be the primary boot drive for the system, the jumper should be set as Cable Select.

How do I jumper a Seagate Maxtor ATA drive?

If you are connecting the drive to an older system that has a pre-UDMA Mode 3 ATA controller, or you are connecting this to a cable with a slave device that doesn’t have a cable select jumper setting, jumper the drive as Master instead by putting a jumper on the first vertical set of pins closest to the data cable.

Where are the Jumper pins on a Seagate Barracuda?

You will want to determine this before installing your new drive, the easiest way is to remove the existing drive from your system and visually inspect it’s hard drive jumpers. Most hard drives have a schematic either silk screened onto the case of the drive, or the schematic is on a label near the jumper pins.

How to set a jumper on a 2.5 ″ hard disk?

Connect the primary (Master) 2.5″ drive to the end of the cable, and the secondary (Slave) device to the middle of the cable. If connecting your drive as the secondary drive on the cable with another IDE device, please ensure that a jumper is connected to pins A-B on the 2.5″ drive. Configure the jumper on the primary IDE device as Master.