What is the throttle actuator control system?

A Throttle Kicker Actuator is a component of the throttle control which helps to regulate throttle control in situations where additional throttle is needed suddenly or when there is a sudden drop in throttle needed.

What does code p161b mean?

p161b indicates a TCM power issue… The TIPM is a known issue will need a professional scanner and diagnostic trees Has the TCM been flashed, a new TCM installed or the battery or TCM disconnected with the ignition in the On or Accessory position? >>>>>>>>>> Yes • This is a normal condition.

What does engine code P2111 mean?

throttle actuator control system
The error code P2111 usually refers to the throttle actuator control system which is stuck open. The engine computer controls the throttle motor. The P2111 error code will be set if there is any movement by the PCM from the throttle motor.

How do I adjust my electronic throttle control?

How do you adjust a throttle body sensor? Loosen the throttle position sensor retaining screw with a Phillips-head screwdriver. Adjust the TPS by moving it back and forth until the voltage is between 4.0 and 5.5 volts. Hold the TPS in place and tighten the retaining screw with the Phillips-head screwdriver.

What does battery disconnect TCM internal mean?

Your P161B code is completely normal to see following a battery disconnect. While it has more than one meaning (TCM internal failure is one), the most likely one is simply that power was lost to the vehicle during your battery swap and the PCM and TCM took notice.

Why does my throttle get stuck?

Most commonly, a stuck throttle results from debris getting caught between the throttle tube and handlebar that makes it sticky. This debris can be from a past ride you failed to remove or even during the current ride from roost or from a crash.

What does trouble code p2110 OBD-II mean?

The P2110 OBD-II trouble code is one of number of possible codes that indicates that the Powertrain Control Module (PCM) has detected a malfunction and is limiting the operation of the Throttle Actuator Control System

When does the PCM set the p2110 code?

The PCM sets these when other codes are present that indicate an issue that may be safety related or cause damage to the engine or drivetrain components if not corrected in a timely manner. Code P2110 is set by the PCM to force the Throttle Actuator Control System to limit the RPM of the engine.

What is the p2110 throttle actuator control system?

2007 Chevy Aveo5 Started today after one day sitting fast idle very rough. Checked codes idiot light was on codes P2106,P2110,P2135,P2101. cleaned intake with gum-out just engine running sucking it in. Reset computer codes. Restarted light off ran a little smoother still rough and about 1200 rpm nor…

What does force code P2104 stand for?

This situation is known as activating a fail-safe or limp mode to prevent the engine from accelerating until this malfunction is corrected and the associated code is cleared. There are four codes that are referred to as force codes and they are P2104, P2105, P2106 and P2110.